Voltage stabilizer Eleks Gerts-PRO U 16-3/160 v3.0

The GERTS-PRO U 16-3/160 v3.0 three-phase voltage stabilizer is designed for use in electrical networks with voltage fluctuations from 150 to 260 V. In this range, the device guarantees an output voltage of 220 ±2.3%, achieved through the use of 16 stabilization stages. The Hertz-PRO model range is available in 66, 83 and 106 kW capacities, which corresponds to an operating current of 100, 125 and 160 A per phase.

The features of this stabilizer include a dual LED indicator per phase, a linear loading strip, a mechanical transit (bypass), a floor-standing design, input and output filters for protection against high-frequency interference, and silent operation due to the use of toroidal transformers and thyristor keys.

If it is necessary to obtain a voltage different from 220 V at the stabilizer output, Hertz has a function for adjusting this value in the range of 200-230 V. In manual mode, you can change the output voltage in 1 V increments. In this case, the changes will be applied to all phases simultaneously.

The Hertz-PRO stabilizer has the ability to manually adjust the lower shutdown threshold (60-135 V). This function is in demand for loads with high inrush currents, which, upon startup, may experience a significant voltage drop and emergency shutdown of the stabilizer. When this option is activated, the stabilizer will allow you to start any motor or pump within a minute, even with a voltage drop of up to 60 V in the network.

The built-in phase synchronization mode allows you to instantly disconnect a three-phase load, protecting it from voltage interruptions and power failures in the phases (one or two). This function has manual control and can therefore be disabled at any time. In this case, the phases will operate independently of each other.

It is recommended to install and operate the GERTS-PRO U 16-3/160 v3.0 stabilizer in dry and heated rooms. This device is designed for floor mounting. Connect