Voltage stabilizer Eleks Hertz U 36-3/63 v3.0

The three-phase GERTS U 36-3/63 v3.0 voltage stabilizer is designed for use in electrical networks with voltage fluctuations from 150 to 260 V. In this range, the device guarantees an output voltage of 220 ±1-1.5%, achieved through the use of 36 stabilization stages. The Hertz model range is available in 16.5, 22.5, 27, 33, 41 and 53 kW power ratings, corresponding to operating currents of 25, 32, 40, 50, 63 and 80 A per phase.

The features of this stabilizer include a dual LED indicator per phase, a linear load bar, a mechanical transit (bypass), a floor-standing design, input and output filters for protection against high-frequency interference, and silent operation thanks to the use of toroidal transformers and thyristor keys.

If it is necessary to obtain a voltage different from 220 V at the stabilizer output, the Hertz stabilizer has a function for adjusting this value in the range of 200-230 V. In manual mode, the output voltage can be changed in 1 V increments. In this case, the changes will be applied simultaneously to all phases.

The Hertz stabilizer has the ability to manually adjust the lower shutdown threshold (60-135V). This function is in demand for loads with high inrush currents, which, upon startup, may cause a significant voltage drop and emergency shutdown of the stabilizer. When this option is activated, the stabilizer will allow you to start any motor or pump within a minute, even if the voltage in the network drops to 60V.

The built-in phase synchronization mode allows you to instantly disconnect a three-phase load, protecting it from voltage surges and power failures in the phases (one or two). This function is manually controlled and therefore can be disabled at any time. In this case, the phases will operate independently of each other.

It is recommended to install and operate the HERZ U 36-3/63 v3.0 stabilizer in dry and heated rooms. This device is designed for floor-standing installation.